Alphacool - Alphacool Eiskoffer Light - bending kit per Taglio e Piegatura Tubi Rigidi Alphacool 10/13 e 13/16mm
0 Articolo Articoli
Attenzione: Ultimi articoli in magazzino!
Nessun punto fedeltà per questo prodotto.
More and more fans of water cooling rely on HardTubes for aesthetic and practical reasons. The great challenge for the user is that the pipes need to be bent to fit the water loop. To make this possible, the Alphacool Eiskoffer Light contains most of the tools required to bend the HardTubes quickly and effectively. All you need is a hot air gun and a saw to cut the HardTubes to the desired length. This not only ensures a fantastic looking system, but also makes the assembly of the water cooling much easier.
The Alphacool Eiskoffer Light contains a large circular and a multi-sheet mandrel. This makes it easy to make all desired angles. All mandrels are designed for HardTubes with an outer diameter of 12, 13 or 16 mm. Two fitting stops are included so that the correct length can be measured immediately during bending. These simulate the depth of the Eiszapfen fittings. Four additional feeders with pin stops can be used in a variety of ways. Either as a support to create several radii simultaneously, or as an end stop point.
All feeders and stops can be screwed onto any wooden board. The matching wood screws are included in the set. Two 80 cm long bending inserts for HardTubes with 10 and 13 mm inner diameter are available so that bending of the HardTubes is done correctly. The functions of all included tools are described in detail in the enclosed manual.
The entire tool comes in a sturdy cardboard box. All tools are embedded in thick foam so that the tool is safely stowed away. This means that the tool can always be neatly packed back at the end of the work and the case can be neatly stowed in the desired place.
With the Eiskoffer Light you get a perfect start into your HardTube bending journey, ensuring professional looking bends straight out of the box.
Scope of Delivery